 |
Home |
Company |
Product |
Support |
Contact |
|
LASER
MAINTENANCE ˇˇ |
|
|
|
LENS
TROUBLESHOOT
|
Avoid direct eye exposure
to the laser beam. Note that a reflected laser beam can be just as
powerful as directly coming from the laser unit itself. |
 Keep
the laser free from dust or other contaminates that could cloud or
dirty the laser lens or crystal array. |
 We
recommend using the laser goggles . A direct exposure to the
laser beam may cause severe and irreparable eye damage. |
 Operate
your laser only within the specified temperature range of 10ˇăC
to 35ˇăC. |
 Do
not take apart, modify or dismantle the laser or operate it under
abnormal current load. |
|
 Dirty
lens: If you
see smudges, finger prints, or small particles on the lens, the beam
emitted will look similar to the left pictures. When it happens,
find the micro fiber cloth, which is specifically designed for
cleaning lenses, then fold it over a toothpick .Rub the lens from
side to side but do not press too hard. Gently rotate the cloth in a
twisting motion back and forth. Repeat this until the lense is
clean. |
 Moisture: We do not recommend
using any laser Products in highly humid or foggy conditions. If
your laser device is used in these conditions or submerged in water,
the beam may appear similar to the above picture. You will not be
able to clean this as water has condensed inside the lens or crystal
set. This condition you should Contact TechnicaLaser lasers, however,
will not be covered in your warranty. |
 Scratched
lens: A scratched lens may occur if you accidentally scratch the lens with
a hard or rough surface. The lens of your laser unit is similar to
the left picture, please handle with care. This condition can be
repaired by TechnicaLaser Lasers, however, will not be covered in your
warranty. |
   Mode
shifts:
A mode shift may occur under extreme temperatures. If your laser
unit is too hot or too cold, the beam may appear unstable and look
similar to the above pictures. Please returns to room
temperature, the beam will return to normal mode, TEM00.
The normal operating temperature of all TechnicaLaser Lasers Products is
10ºC~35ºC.
|
| |
|
|
|
| 
|
|
|
 v |
